Hired-hand RollSeal Rollup Curtains: ROLLUP CURTAIN SYSTEM Re Manual do Utilizador descarregar pdf (Página 17)

Part No. 4801-5138 Rev 11-05 Rollup Curtain System Page 17

7.8 Front Windpipes

Now install windpipes to front of system. NOTE: Curtain not shown in diagrams below for clarity.

1. Insert one end of windpipe through hole in top bracket (A).

2. Slide windpipe upward until opposite end of windpipe is above bottom bracket (B). If installing a

double stack system, make sure that wind pipe aligns with slot of middle bracket.

3. Insert end of wind pipe through corresponding hole of bottom bracket (C)

4. Install clamp to middle bracket with #14-1 Tek screws to secure windpipe in place (D). Install

screws through top and bottom brackets to secure windpipe (D).

5. Repeat steps A-D to install windpipes to all front brackets of system.

A B

FIG. 7

Front Windpipes

NOTE: Single System installs by the same procedures

except there is no middle stringer.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Sem comentários

Hired-hand RollSeal Rollup Curtains: ROLLUP CURTAIN SYSTEM Re Manual do Utilizador Página 17